網站首頁
紫外紅外探測器
紅外光束感煙探測器
點型火災消防系統
火災報警多線系統
促銷產品
家用報警器
總線報警系統
多線報警系統
產品目錄
獨立煙感
多線煙感
多線溫感
多線報警主機
氣體滅火系統
多線按鈕警鈴聲光
可燃氣探測器/一氧化碳探
開關量探測器
天成消防報警系統
紅外防盜報警系統
三江消防報警系統
防威總線系統
最新消息
聯繫我們
文件下載

產品目錄 

 

多線溫感WT105c

2線非編溫感
  • 2線非編溫感
  • 多線溫感WT105c
  • 多線溫感WT105c
  • 多線溫感WT105c
型號︰-
品牌︰-
原產地︰中國
單價︰CNY ¥ 35 / 件
最少訂量︰10 件
分享到:

 共有 3 相關信息  
123下一個

產品描述

The detectors are photo-electronic detector uses a state of-the-art
optical sensing chamber. This detector is designed to provide open
area protection and to be used with most conventional fire alarm
panel.
Two LEDs on each detector provide local 360° visible alarm
indication. They flash every six seconds indicating that power is
applied and the detector is working properly. The LEDs latch on in
alarm. LEDs will be off when a trouble condition exists indicating
that the detector sensitivity is outside the listed limit. The alarm can
be reset only by a momentary power interruption.
The detector that initiated the alarm condition will have its red LED
and relays latched until reset by panel.
Heat detector and smoke & heat detector combine a photo
electronic sensing chamber and a temperature heat detector.
2. SPECIFICATIONS
Operating Voltage Range: 9 to 28 VDC Volts Non-polarized
Standby Current: ≤60μA@24VDC
Maximum Alarm Current (LED on): ≤30mA@24VDC
(1K Ohm current-limiting resistance)
Operating Humidity Range: ≤95%RH(40°C±2°C) Relative Humidity, Non-condensing
Operating Temperature Range: -10°C to 50°C (14°F to 122°F)
Smoke Alarm Sensitivity: 0.15-0.3dB/m
Temperature Alarm Sensitivity: 57°C (135°F) A1R (only for with heat sensor)
Height: 48 mm installed in Base
Diameter: 99 mm
3. INSTALLATION
NOTE: All wiring must conform to applicable local codes,
ordinances, and regulations.
INSTALL THE DETECTOR BASE
1. Open area smoke or heat detectors are intended for
mounting on a ceiling or a wall in accordance with the fire
standard in your country.
2. Attach mounting base to ceiling or wall. The base of
the detector can be mounted directly onto an electrical
junction box such as an octagonal (75mm, 90mm or
100mm), a round (75mm), or a square (100mm) box
without using any type of mechanical adapter.
3. Position all wires flat against terminals, and fasten the
wires on the terminals, See Figure 1.
4. Terminals functions description:
Terminal 2: IN+( Zone Input+)
Terminal 5: IN- (Zone Input- )
Terminal 6: IN+( Zone Output+)
Terminal 5: IN- (Zone Output- )
Terminal 6: Remote Indicator+

產品圖片

2線非編溫感
2線非編溫感




相關產品
2線傳統溫感
多線溫感WT105
CNY ¥ 33
溫感報警器
差定溫火災探測器
CNY ¥ 40

網站首頁  |  紫外紅外探測器  |  紅外光束感煙探測器  |  點型火災消防系統  |  火災報警多線系統  |  促銷產品  |  家用報警器  |  總線報警系統  |  多線報警系統  |  產品目錄  |  最新消息  |  聯繫我們  |  文件下載  |  網站地圖  |  手機版
  English     简体版     繁體版
Powered by DIYTrade.com